Disconnect all three wiring harnesses from the ECM. Use the following procedure in the CELECT™ Electronic Control System L10, M11, and N14 Engines, Bulletin 3666084. Refer to Procedure 019-031 in Section 19.

Remove the six ECM mounting capscrews. These capscrews are metric.

Remove the ECM from the cooling plate.

Remove the inlet and outlet fuel hoses from the cooling plate.

Remove the four cooling plate mounting capscrews. Do not lose any of the heat resistant grommets. The heat resistant grommets are on both sides of the cooling plate. One of the mounting locations has heat resistant star washer grommets on both sides of the cooling plate.

Remove the cooling plate